▲The main material requirements are high-strength aluminum alloy profiles, not less than 6063, and the processing grade reaches T5 standard. The overall fully enclosed design, no sharp angle on the surface, no exposed screws.

▲The inside of the suspension bridge box adopts a gas-electricity separation design to ensure the safety of use: the bottom end of the box must have an oxygen drain hole design to prevent the accumulation of oxygen in the tower and the power line caused by fire accidents

▲The suspension bridge box bearing adopts needle roller type, and the number of rotations is not less than 100,000 times.

▲The suspension bridge has a safety load device with four times the load-bearing coefficient.

1. Working power: AC220V, 50Hz; Input power: 6KVA;

2. The bridge body is designed with an arc-type inner groove, and the length of the bridge body is 2000~3000mm (the actual size is subject to the actual measurement of the user's site); The beam is 500mm wide and 220mm high.

3. Equipped with ambient lighting *2pcs, optional LED auxiliary lighting with independent suspension arm system, the number of LED lamp beads ≥ 28, the diameter of the lamp head is ≤ 20cm, and the illuminance ≥ 35000LUX

4. Wet section tower: 1pc, using imported linear guide rail, the tower body can move left and right distance ≥ 500mm.

5. The wet section box rotates ≥ 340º, the height ≥ 800mm, and the width ≥ 450mm. The diamond-shaped box has no angular design, and the left and right sides of the box are equipped with a stainless steel infusion pump bracket, and the syringe pump frame is fixed up and down, the upper section is a four-section pagoda-shaped, and the lower section is a spiral fixed structure.

6. The center distance between the infusion pump brackets on both sides is ≥ 500mm;

7. Instrument platform: 2 layers (bearing weight≥ 50Kg, height adjustable), pallet thickness 230mm, length ≥ 440mm, width ≥ 430mm, length (including side rail size) ≥ 510mm, stainless steel side rails on both sides length ≥ 350mm, width ≥ 10mm, height ≥ 20mm, optional hanging net basket, etc

8. The pallet fixing method adopts reinforced aluminum alloy tripod support, the length of the tripod is ≥ 155mm, and the thickness is ≥7mm;

9. Drawer: 1pcs, carrying weight≥ 20Kg. Drawer inner diameter ≥ 40mm, width ≥ 270mm, height ≥ 70mm, drawer with automatic suction design;

10 gas terminal standard configuration: oxygen *2pcs, negative pressure suction *2pcs, compressed air *1pcs; Optional negative pressure suction device, oxygen supply system oxygen inhaler

11. Power sockets: 6pcs, 220V, 10A (compatible with international plugs);

12. Grounding terminal: 2pcs; Network interface: RJ45, 1pc;

13. Trunk section tower: frame structure design, 1pc (can move left and right distance≥ 1000mm).

14. The overall frame is made of 304 stainless steel, the beam length is 650mm, the beam width is 60mm, and the beam height is 40mm;

15. Instrument platform: instrument platform: 2 layers (bearing weight≥ 50Kg, height adjustable), tray thickness 230mm, length ≥ 540mm, width ≥ 440mm, two frame distance 620mm, optional hanging net basket, etc

16. Drawer: 1pc, carrying capacity≥ 20Kg. Drawer inner diameter ≥ 40mm, width ≥ 250mm, height ≥ 60mm, drawer with automatic suction design;

17. Ceiling installation, stable and firm.